Electrical power systems

Short transmission lines: phaser diagrams

2007-06-23T13:42:59+02:00

Short transmission lines:

Here sending current is equal to receiving current .But sending & receiving voltages are not equal to due to impedance voltage drop in the transmission line.

Vs=Vr+IZ

Receiving end voltage lag by  angle with respect to sending end voltage. In practical situation step-up and step –down transformer is used at sending end and receiving end of the transmission line as below.

Therefore total impedance can be implemented as Z=Z_T1+Z_L+Z_T2

This can be equivalent to single phase circuit as below and transformer impedance can be assumed as series impedance.

Comments

google analytic

2007-06-18T05:47:16+02:00

google analytic is a another way of tracking your web site statistics. It shows the country , network , location , no of views, etc who came to your site.

_uacct = "UA-1944987-3"; urchinTracker();

Comments

page rank

2007-06-17T20:24:38+02:00

page rank buttons will display your site rank on web!

Comments

statics

2007-06-17T20:14:28+02:00

Comments

Moderatively long lines

2007-06-17T19:48:30+02:00

Morderately long lines:

*Transmission lines between 80km and 240km can be assumed under this category.
*These transmission lines represented by T or π.

Vs=Sending end voltage for single phase
Vr=Receiving end voltage for single phase
Is=Sending end current
Ir=Receiving end current for single phase
Z=R+jX
Y=G+jB
G=leakage conductance per phase
B=Capacitive susceptance

Normally moderately long lines leakage may also be ignored. Therefore Y=G+jB=jwc0
W=Radian frequency of the power supply
C0=Capacitance to neutral of the transmission line.

Long lines:
*Te lines beyond 240km can be named as long lines.
*In Sri lanka, long lines cannot be seen yet!
*In long lines impedance & admittance assumed uniformly distributed.

Comments

Introduction to power systems

2007-06-17T18:35:20+02:00

Electrical Power Systems

Power system engineering is special branch of electrical engineering. Power engineering can be mostly touch with transmission, distribution &technology.
The special responsibility of a power system is that, in addition to maintain the generation of electrical power at adequate level, the power has to be transmitted to the various load levels.
Power system engineer should have a knowledge regarding the operation & control of inter connected power systems, specially when inter connecting the local grid to form an integrated power pool.
Power engineering never falls down, because of energy crises all over the world. But lots of connecting problems , energy (voltage) converting problems , & planning operation problems may occur in the field while working.
There are three major classification in transmission lines.
1. Short lines
2. Moderately long lines
3. long lines

Comments